The results of a study released today by Spinal Resources, Inc., demonstrate that Bezier-surfaced continuously tapered spinal fixation rods provide advantages to both surgeons and patients over standard constant diameter rods, as well as over stepped-reduction-in-diameter rods in correcting spinal deformities.
According to researcher Dr. Craig Slyfield, “Excessive implant stiffness is known to result in stress shielding-induced implant loosening and failure as well as post-operative proximal junctional issues. To address these issues, stepped and conical fixation rods with reductions in outer diameter have been introduced to gradually transfer additional load to spinal segments proximally.” Dr. Slyfield continues, “It is exciting such technologies are being developed in an effort to address Proximal Junction Kyphosis (PJK) and spinal fixation implant failure.”
Continuously tapered spinal fixation rods give surgeons greater control over rod and screw placement, allowing them to accommodate the geometry of the patient’s spine – not the rod design. The continuous rods showed a reduction in stresses at the diameter transition junctions, better screw-bone contact pressures, and reduced material stresses in screw necks as compared to both constant diameter and stepped rods. The improvement in screw neck stress should lead to a reduced risk of screw neck breakage.
“Proximal and distal junctional issues remain one of the main causes of failure in adult deformity surgery in thoracolumbar and cervical deformity surgery,” states Christopher Ames, MD, Director of Spinal Deformity and Spine Tumor Surgery and Co-director of the combined High Risk Spine Service, the Neurospinal Disorders Program, and the UCSF Spine Center. “Further development work in stress transition solutions such as ligament augmentation and improved rod stiffness transitions at proximal and distal junctions are likely to be our best solutions in combination with patient-specific alignment planning. These surgeries tremendously benefit our aging population with spinal problems and, therefore, it’s encouraging to see these types of innovations being developed.”
“We anticipate the initial release of the rod-based technology along with the individual diameter 4.75, and 5.0 diameter rods around the third quarter of 2021,” projects Bernie Bedor, President and Chief Executive Officer of Spinal Resources, Inc. “We are delighted with the development of our pipeline and look forward to advancing the rod-based technology into a Posterior Cervical platform in 2022.”
To learn more about the methodology behind the research and the findings, click here.
About Spinal Resources, Inc.
Spinal Resources, Inc.® is a Florida-based spinal medical device company that supports cost-effective patient case with innovative mechanical and bio-mechanical products to alleviate pain, shorten recovery time, restore health, and extend quality of life. For more information, visit www.spinalresourcesinc.com.
View source version on businesswire.com: https://www.businesswire.com/news/home/20210304005950/en/
Source: Spinal Resources, Inc.